- up to 250 Wp module output
- max. 15 A module current
- max. 50 V module voltage
Charging options: 1 supply battery and 1 starter battery
Votronic solar controllers of the "MPP" (Maximum Power Point) series with "IU1oU2" charging characteristic are connected as a link between the solar panel(s) and battery(ies).
With MPP technology, the controller automatically determines the maximum power output (MPP) of the solar modules several times per second. It then transforms the excess voltage of the solar module into a higher charging current for the battery (realized by high-frequency switching regulator technology with high efficiency). This additional charging current ensures shorter charging times and the best possible power utilization of the solar system.
MPP solar controllers work fully automatically, are maintenance-free and offer the following functions:
- MPP charging current increase of 10 % to 30 % (efficiency > 95 %) compared to conventional controllers thanks to the use of state-of-the-art controller technology (microprocessor). The increase in performance is particularly noticeable in the cooler months of the year and, for example, during periods of high fog, low and diffuse lighting (overwintering).
- Switchable charging characteristics for optimum charging of gel/dryfit, AGM/non-woven or acid/wet and LiFePO4 batteries (see Table 1).
- The charging voltage is peak-free and regulated to prevent overcharging of the batteries.
- Two battery charging outputs: Automatic charging of the main or on-board battery (Board I), support charging and charge retention (max. 1 A) of the vehicle starter battery (Start II) with protection against overcharging.
- Monitoring-free charging:Standard protection against overload, overheating, reverse polarity and reverse battery discharge (if solar power is too low, e.g. at dusk, at night, etc.).
- Parallel/buffer operation:Maintains charging characteristics even when loads are operated simultaneously.
- Overcharge protection:Regulates back the charging current of the battery if there is too much solar power and the battery is full, ensures the highest possible state of charge of the battery by immediately recharging when power is consumed.
- "IU1oU2" charging characteristic:Defined charging voltage increase (U1) prevents harmful acid stratification and ensures equalization charging of the individual battery cells, followed by automatic trickle charging (U2).
- Charging cable compensation:Voltage losses on the charging cables are automatically compensated for.
- On-board power supply filter:Problem-free parallel operation with wind and petrol generators, mains chargers, alternators, etc.
- Measurement output for EBL (vehicle electrical block):Enables convenient use of the (solar) current display built into the electrical block to check the solar system.
- Switching output "AES" (onlyMPP250Duo Dig.andMPP350Duo Dig):Causes the ELECTROLUX/ DOMETIC refrigerators with "AES" (Automatic Energy Selector) to switch automatically from gas to 12 V operation when there is plenty of excess solar power.
- Connection for temperature sensor (art. no. 2001): Automatic adjustment of the charging voltage to the battery temperature. Improves full charging of the weaker batteries in cold weather. It is highly recommended if the battery is exposed to strong temperature fluctuations, e.g. in the engine compartment.
- Ready to plug in for connecting the Votronic solar display units for optimum control of the system: LCD Solar Computer S: LCD display with display range: battery voltage, charging current, charging power, stored capacity and energy (V, A, W, Ah, Wh).
Scope of delivery:Operating instructions