The adhesive collar that lets you attach your Mopeka PRO sensor to an aluminum or composite gas cylinder. The sensor’s magnet only sticks to steel. For gas cylinders made of aluminum or composite material—that is, the vast majority of lightweight cylinders found in RVs—you’ll need this adhesive frame: Place the sensor in the notch, peel off the protective film, and stick the frame to the bottom of the cylinder. Done—no drilling or tools required.
Make sure youchoose the correct version. The adhesive frame comes in two shapes. This is the curved version: Its flange is angled to follow the curve of the cylinder’s base. For water tanks and anything with a flat bottom, you’ll need the flat version instead, which we also carry.
Compatible with both sensor types. The curved collar works with both magnetic and non-magnetic PRO sensors—even on steel tanks, if you prefer to permanently glue the sensor in place rather than attaching it magnetically.
Details:
- Attaches Mopeka PRO sensors to non-magnetic gas cylinders
- For aluminum and composite cylinders; also suitable for steel tanks
- Curved flange for round contact surfaces
- Adhesive strip is already applied—peel off the protective film and press firmly
- Preparation materials for cleaning the adhesive surface are included
Technical Specifications:
- Compatible with Mopeka PRO sensors (magnetic and non-magnetic)
- Design: domed contact surface (gas cylinders)
- Color: gray
- Material: Plastic
- Manufacturer Part Number: M2002012 (Universal Collar Set, LPG Cylinders)
- EAN: 4250959461582
Package contents:
- 1 × Mopeka adhesive frame, curved, with pre-applied adhesive
- Preparation materials for the adhesive surface
At a Glance:
- For aluminum and composite gas cylinders to which the magnet does not adhere
- Domed design—not for water tanks
- Compatible with all Mopeka PRO sensors
- Installation without drilling or tools
Frequently Asked Questions
Is the sensor included?
No, you only receive the adhesive frame.
I have a water tank—will this work?
No. For flat surfaces, you’ll need the flat version. You can find it on our website as “Mopeka Adhesive Frame for PRO Sensors, Flat.”
Can I remove the frame later?
The adhesive is designed to be permanent. So think carefully about the position beforehand and clean the surface thoroughly with the included preparation materials—poor preparation will compromise adhesion and, consequently, measurement accuracy.