HEOSafe Van Security, lock for securing sliding, rear and hinged doors

HEOSafe® Van Security
Special lock for securing sliding, rear and hinged doors


OPERATING INSTRUCTIONS

- The lock can only be used with the key.
- The lock is unlocked with the key and is then turned 180°.
- The key can only be removed in the open or closed position.
- Always keep a key with you.

ASSEMBLY INSTRUCTIONS

- Unlock the lock with the key and turn it 90°. This position is the installation position and you cannot remove the key in this position.
- Mark the 4 holes with a pen. The best way to do this is to hold the lock with the plate in the correct position.
For the sliding door, the lock is fitted to the side panel next to the sliding door (ideally approx. 10 cm above the guide rail). Before proceeding, please check that the sliding door also slides smoothly over the lock.
For the hinged door, fit the lock on the side of the door that can be locked from the inside.
- Drill the holes with a 3.20 mm drill bit.
- Grease the holes, apply a foam rubber seal over the holes.
- Using a 4 mm Allen key, fasten the lock with the special self-tapping screws supplied.